bopsdesert.blogg.se - Bartender 10.1 printer printing too light

BARTENDER 10.1 PRINTER PRINTING TOO LIGHT DRIVER
BARTENDER 10.1 PRINTER PRINTING TOO LIGHT PLUS
BARTENDER 10.1 PRINTER PRINTING TOO LIGHT SERIES

Check with your media supplier if you have tried all suggestions without success.

BARTENDER 10.1 PRINTER PRINTING TOO LIGHT PLUS

Media must be matched if the ribbon is used, applicable to (TLP2824 Plus Only) and if no ribbon is used, verify the quality of the Direct Thermal stock.Refer to: User Guide: Adjusting the Printer Width.

BARTENDER 10.1 PRINTER PRINTING TOO LIGHT SERIES

Refer to this article: Video: LP or TLP Series Printer Printhead Cleaning.

Contamination can cover the elements preventing heat transfer.

NOTE If there is a flood coating or preprint on the label surface where the print issue is occurring check with your supplier for corrective action. NOTE If the problem occurs after printing from your application, verify your driver/software configurations. Print is faded or too light when printing self-test Make sure all settings match the printer settings to avoid intermittent issues. The host device that generates the printer commands for printing typically has a setup configuration that sends these as commands to the printer.

BARTENDER 10.1 PRINTER PRINTING TOO LIGHT DRIVER

A printer that is functioning fine after setup but fails or indicates an error after label requests are received is most likely affected by the host side misconfiguration of the driver or printer software settings. IMPORTANT! All printer settings can be impacted by commands from a mismatched or misconfigured driver or software application. For more information, refer to the ZebraDesigner Driver Printer Configuration Printing Preferences vs Printing Defaults article. (Go to Printing Preferences > Options > Darkness).

Try varying the darkness to produce the best print quality.įor example: To set the darkness using the ZebraDesigner Driver, follow these steps: Avoid overheating the ribbon as it can melt if it is set too high. Print Darkness also referred to as (Density or Burn Temperature) is a user-adjustable setting. (Go to Printing Preferences > Options > Print Speed).įor more information, refer to the ZebraDesigner Driver Printer Configuration Printing Preferences vs Printing Defaults. If your application requires the highest print speeds available, be sure your media supplier has recommended the correct media for your application.įor example: To set the print speed using the ZebraDesigner Driver, follow these steps: The speed selection takes the media or ribbon (if used) compatibilities into consideration since if high darkness settings are required to achieve acceptable print, then slower rates should be used. The printer is capable of printing at multiple print speeds. There are no printhead pressure adjustments on the G-Series Printer. Trying to compensate for poor media compatibility by using high printhead pressure and/or darkness settings can impact your printer’s printhead life. Printing speed, the durability of the image or media, environment are just a few factors to consider when determining the printer setup for the application. Not all media are the same when it comes to being compatible with your application or needs. The four impacting factors to consider are: Print quality is a product of proper printer setup and the use of compatible media for the application. Zebra provides utilities for printer setup (refer to Helpful Information below) but once you have established your application driver or software or program, you will need to determine the methods used for modification of the printer settings. If there are changes that are needed for the printer settings, determine your application's method used to alter these settings.įor example: If you need to increase or decrease the darkness setting, you will need to determine if this action is performed on your driver, or application, or both. NOTE The printer can be configured using any number of applications, utilities, or using a Zebra Printer Driver.